There is a device args field in the current version of GNU Radio, so
this might be where the confusion comes from.
On 26.05.2014 05:41, Marcus D. Leech
wrote:
On
05/25/2014 11:39 PM, jason sam wrote:
"device args" parameter is not in the UHD
USRP source/sink block?There is only 'Device addr'
Sorry, I meant Device Addr
On Fri, May 23, 2014 at 9:39 PM, Marcus D. Leech
<address@hidden <mailto:address@hidden>>
wrote:
On 05/23/2014 12:23 PM, raf raf wrote:
Hello All Gnu Radio user,
To use a 2 TX, I want to change a clock rate to an
accepted one,
under 30.72 MHz. I use the API with uhd_usrp_probe and it
works
only for this command. Can you give me the idea or python
code to
use this argument parameter with a python flowgraph?
--args="master_clock_rate=28"
Thanks.
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
<mailto:address@hidden>
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
In GRC, where it has a "device args" parameter, that's wher
this
master_clock_rate=28e6 should go. I assume you meant 28e6,
rather than 28.
Everything is in Hz, and there's no way the B200 can go
down to
a clock rate of 28Hz.
-- Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
<mailto:address@hidden>
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
|