discuss-gnustep
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Installing GNUstep on Win32 with gnustep-system-0.24.0-setup.exe and


From: Tim Kack
Subject: Re: Installing GNUstep on Win32 with gnustep-system-0.24.0-setup.exe and SVN
Date: Sun, 08 Nov 2009 22:53:06 +0100

Hi Paul,

I found a couple of places - these on on GNUstep ftp even:
http://ftpmain.gnustep.org/pub/gnustep/libs/

http://www.gtk-server.org/shared/libffi-mingw.zip (precompiled for
mingw)
And last but not least - the original source: 
ftp://sourceware.org/pub/libffi/libffi-3.0.8.tar.gz

I had some issues last time I tried to compile libffi on mingw and have
given up that and instead use the ones in the Gnustep windows installer.

Best regards,
Tim


On Sun, 2009-11-08 at 22:33 +0100, Paul Csanyi wrote:
> Hi,
> 
> 2009/11/8 Adam Fedor <address@hidden>:
> >
> > On Nov 7, 2009, at 12:08 AM, Paul Csanyi wrote:
> >
> >> Hi,
> >>
> >> I want to install GNUstep system and development tools: Gorm and Project
> >> Center
> >> on my Win32 system.
> >>
> >> I have downloaded and installed the gnustep-system-0.24.0-setup.exe.
> >>
> >> I have set up the HOME environment variables to C:/ in
> >> Start / Control Panel / System / Spetial (or Advanced?) / Environment
> >> variables...
> >
> > If you want the latest release, you should install
> >
> > gnustep-system-0.23.0-setup.exe
> > gnustep-core-0.23.00setup.exe
> >
> > and then try to compile Gorm and ProjectCenter.
> >
> >
> > If you looking to get the latest code from SVN, you can install
> > gnustep-system-0.24.0-setup.exe, but then I would configure make with:
> >
> >  ./configure --prefix=/GNUstep --with-config-file=/GNUstep/GNUstep.conf
> >
> > Note, you'll also need to download and install libffi and gnustep-objc
> 
> OK
> I have downloaded gnustep-objc from SVN in C:\modules\dev-libs\libobjc
> 
> so there I can shall install it.
> 
> But from where can I download the libffi sources?
> 






reply via email to

[Prev in Thread] Current Thread [Next in Thread]