Re: Acciaccaturas and slashed stems

[David Kastrup]

Peter Bjuhr <address@hidden> writes:

> On 09/28/2013 09:27 AM, David Kastrup wrote:
>> There are only three rather glaringly obvious reasons I can think of:
>>
>> a) you are not running the rebuilt executable
>> b) the rebuilt executable is in a place where it accesses the old
>>     engraver-init.ly
>> c) you are looking at the wrong PDF file
>>
>>
>> If you get a complaint about an unknown engraver, you have the wrong
>> executable.  If the first grace is beamed, everything is fine (don't
>> know what the second will be, with two engravers active).  If the second
>> is beamed, you are using the wrong engraver-init.ly.
> Thanks a lot for the debug script! I get this:
>
>> warning: unknown translator: `Grace_auto_beam_engraver'
>>
>> warning: cannot find: `Grace_auto_beam_engraver'
>>
>
> So then it's alt. a)!? My interpretation is that I don't seem to be
> able to compile the changed files on disc (I'm using Janek's script
> which he introduced to me some weeks ago).

They are probably compiled, but that does not _install_ them.  You
should be able to run LilyPond from out/bin/lilypond without installing
it.

-- 
David Kastrup