[Partysip-dev] Re: problem with ringing tone

[luke dobson]

> > Hi All
> >
> > I am using partysip to connect two ciso ATAs together.  I can make calls
> > and the voicepath is fine but I have a small problem.  I have two
> > numbers 10 and 20
> >
> > 10 dials 20#
> > 20 starts to ring
> > there is no ringing tone at 10!
> >
> > My understanding of the message flow is this.
> > 10 sends an invite to the SIP which forwards to to 20
> > 20 sends a "180 ringing" signal back to 10.    <-- I don't think this is
> > arriving.
>
> Right, partysip is not yet complete and when running in statefull mode,
> the provisionnal response are not forwarded. I have to rewrite some part
> of the code in this module and any quick hack to forward 180 will be
> a useless effort. Anyway, the next version will probably forward them.

Fair enough.

> > When I look in the logfile I don't see the reply.

>
> Can you confirm that the 180 is sent to partysip and not forwarded
> to the caller? This is the expected and wrong behavior...

I have just used a packet sniffer.  Phone 1 called phone2.  The 180 message
definately goes from phone2 to partysip but no 180 message emerges from
partysip to phone1.

> Aymeric
>
> > When I get the two phones to ring each other without SIP I get ringing
> > tone.
> >
> > Is this a partysip bug?
> >
> > Thanks in advance for any help
> > Cheers
> > Luke Dobson

At least I know my config is okay!

Thanks
Luke Dobson