[Qemu-devel] [PULL 06/30] sd: sdhci: Remove block count enable check in single block transfers

[Peter Maydell]

From: Prasad J Pandit <address@hidden>

In SDHCI protocol, the 'Block count enable' bit of the Transfer
Mode register is relevant only in multi block transfers. We need
not check it in single block transfers.

Signed-off-by: Prasad J Pandit <address@hidden>
Message-id: address@hidden
Reviewed-by: Alistair Francis <address@hidden>
Signed-off-by: Peter Maydell <address@hidden>
---
 hw/sd/sdhci.c | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c
index c270e09..6d6a791 100644
--- a/hw/sd/sdhci.c
+++ b/hw/sd/sdhci.c
@@ -570,7 +570,6 @@ static void sdhci_sdma_transfer_multi_blocks(SDHCIState *s)
 }
 
 /* single block SDMA transfer */
-
 static void sdhci_sdma_transfer_single_block(SDHCIState *s)
 {
     int n;
@@ -589,10 +588,7 @@ static void sdhci_sdma_transfer_single_block(SDHCIState *s)
             sdbus_write_data(&s->sdbus, s->fifo_buffer[n]);
         }
     }
-
-    if (s->trnmod & SDHC_TRNS_BLK_CNT_EN) {
-        s->blkcnt--;
-    }
+    s->blkcnt--;
 
     sdhci_end_transfer(s);
 }
-- 
2.7.4