[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [avr-gcc-list] SPI debugging code, was: IAR vs GCC

From: Jesper Hansen
Subject: Re: [avr-gcc-list] SPI debugging code, was: IAR vs GCC
Date: Fri, 15 Jun 2001 08:49:14 +0200

Hi Dale, Thorsten et al.

I should have seen it coming ;-)
While I'm using the programmer daily for my 8515, 2313 and mega103
needs, it's not complete. There's currently no fuse support at all, as I'm
not using this.
The plan was ofcourse to put all the bells and whitsles in it, but I never
felt the need.

Let me shine it up a bit and document a few things, and I'll then put it on
my web-site. You can then use it "as is".


> > In my AVR programmer I've built a complete debugging terminal
> > using the SPI. Makes it easy to debug, as you already have the cable
> > connected.
> sounds good to me. Did you published this code anywhere? Is it included
> in the yampp sources? And is there some documentation about it?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]