[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: multiple fret-diagram-x markup commands and lilypond-book safe-mode

From: Patrick McCarty
Subject: Re: multiple fret-diagram-x markup commands and lilypond-book safe-mode
Date: Sat, 13 Nov 2010 13:51:02 -0800
User-agent: Mutt/1.5.21 (2010-09-15)


Sorry for the delay.

On 2010-11-04, Julien Rioux wrote:
> On 04/11/2010 7:34 PM, Patrick McCarty wrote:
> >Are you compiling LilyPond from scratch
> by the way for my builds initially I did
> git clone git://git.sv.gnu.org/lilypond.git lilypond
> ./autogen.sh
> ./configure.sh
> make
> sudo make install

You don't need the ./configure in there, since ./autogen.sh
automatically invokes the configure script.

But it doesn't hurt to run the script twice :)

> Since then I have been doing
> git pull
> make
> sudo make install
> I suppose I don't need to make clean each time I pull? Or should I?

Sometimes I find that a `make' doesn't catch all of the changes to
python scripts (e.g. lilypond-book), so I would do a `make clean' or
`make bin-clean' just to be safe.  The bin-clean target doesn't clean
the font build directory, so this saves some compilation time.

If you want to start again with a pristine git checkout (I don't know
if this is in the Contributor's Guide yet), the following command
sequence usually works for me.

  make doc-clean
  make distclean
  git clean -f -x

Then proceed with ./autogen.sh , etc. to rebuild.

Let me know if you still have problems after trying this.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]