[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Discuss-gnuradio] USRP + case = electrical short??

From: Weber, Michael J. \(US SSA\)
Subject: RE: [Discuss-gnuradio] USRP + case = electrical short??
Date: Fri, 2 Mar 2007 11:58:22 -0500

George, thanks for the information!

I would be very surprised if the USRP design did not intend to allow for
RF grounding to a case, but I supposed it's possible. Good grounding is
essential to good RF performance, especially with the proximity of the
analog and digital circuits.

Matt, is this in fact the design, or is this behavior a fluke?


-----Original Message-----
From: address@hidden
On Behalf Of George Barrinuevo
Sent: Thursday, March 01, 2007 8:56 PM
To: address@hidden
Subject: Re: [Discuss-gnuradio] USRP + case = electrical short??


I experienced a similar issue with my BasicRX and other daughterboard.
Here is what I found.  When all is working fine, the motherboards green
LED blinks. 
Otherwise, it does not blink or come on when there is a short.  When I
loosened the nut/washer that holds the SMA jumper cable to the case, the
short went away.
 It appears that when this nut it tightened too much, the locking washer
will bite through the black pant on the enclosure and make contact with
the enclosure metal which causes a short.  My solution was to loosen
this nut a bit.

A better solution is to find plastic thin washers and use this instead
of the locking washers supplied with the enclosure.  However, I was not
able to find a plastic washer in the right size.  Someone on this
mailing list used a sheet protector with an exacto-knife to cut out a
shape of a washer.

Does anyone have a better/easier solution to this problem?


--- "Weber, Michael J. (US SSA)"
<address@hidden> wrote:

> Hello,
> I have a USRP with an RFX2400 mounted on the A side and a FLEX900 
> mounted on the B side. Everything works great UNTIL I connect the SMA 
> jumpers from a TX/RX port on either board to the case. When the 
> connection between the TX/RX ground and the case is made, a short 
> occurs, the regulator gets very hot, and the voltage at the input jack

> drops to about 2V. Of course I disconnected the power as soon as I 
> discovered what was happening. The board seems happy out of the case, 
> or even in the case if the antenna port jumpers are not installed. I 
> have to other units just like this one running with no problems, 
> though one of them has a FLEX400 instead of a FLEX900.
> So... any ideas where the short is? I inspected the case and USRP but 
> didn't see anything telling, but there's a lot of tiny components and 
> traces.
> Help?
> Thanks,
> Mike
> -----------------------------
> Mike Weber * 703-668-4516
> Network Engineer, BAE Systems
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden

George Barrinuevo

Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]