[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] recv_async_msg questions

From: Josh Blum
Subject: Re: [Discuss-gnuradio] recv_async_msg questions
Date: Thu, 09 Sep 2010 10:24:01 -0700
User-agent: Mozilla/5.0 (X11; U; Linux i686; en-US; rv: Gecko/20100826 Thunderbird/3.0.7

I envisioned a way to send a burst with a request to ACK. If you enabled the ACK, you would expect a async message to come back either one of the errors or a success. This is not implemented.


On 09/09/2010 09:54 AM, Marc Epard wrote:
As far as I can tell, EVENT_CODE_SUCCESS (Defined as success: a packet was 
successfully transmitted) events never seem to happen. That's okay with me and 
I'd worry about the bandwidth they'd take if I were transmitting and receiving 
at the same time. Are they just not implemented, yet?

I need to start and stop transmitting, do some work, and go around again. I 
think I'm seeing residual events after I end a burst. Should I use the 
metadata's timestamp to filter them out or is there a way to flush the queue of 


Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]