Re: [Discuss-gnuradio] 3.6.4.2 test fail

[Nemanja Savic]

I deleted everything concerning my module and installed it again, at it works now. I hate things like that :).

Thank you all guys again.

P.S. After making 3.6.5.1 teset shown error in udp source aas far as i remember, but then i run ctest -V and there was no error.

Best,

Nemanja

On Wed, Sep 4, 2013 at 3:15 PM, Tom Rondeau <address@hidden> wrote:

On Wed, Sep 4, 2013 at 4:45 AM, Nemanja Savic <address@hidden> wrote:
> After installing 3.6.5.1 there is a problem while when running flowgraph.
> Flowgraph won't start, and the error is following:
>
> Using Volk machine: avx_64_mmx
> -- Loading firmware image: /usr/local/share/uhd/images/usrp1_fw.ihx... done
> -- Opening a USRP1 device...
> -- Loading FPGA image: /usr/local/share/uhd/images/usrp1_fpga.rbf... done
> -- Using FPGA clock rate of 64.000000MHz...
> *** glibc detected *** /usr/bin/python2.6: malloc(): memory corruption:
> 0x0000000005661000 ***
> *** glibc detected *** /usr/bin/python2.6: malloc(): memory corruption:
> 0x0000000005661000 ***
>
> Is this problem due to python 2.6 maybe?
>
> Cheers

Shouldn't be. I believe that I've tested 3.7 using Python 2.5 and 2.6.

How about just starting gnuradio-companion and seeing if you can run a
simple flowgraph without any hardware?

Did ctest (or 'make test') pass?

--
Tom
Visit us at GRCon13 Oct. 1 - 4
http://www.trondeau.com/grcon13

> --
> Nemanja Savić

--
Nemanja Savić