|
From: | Ihab Zine |
Subject: | [Discuss-gnuradio] DVBT project receiver probelm |
Date: | Thu, 26 Nov 2015 15:59:55 +0000 |
Hi,
I’m trying to receive a live signal from an antenna on the roof
through a cable connected to my SDR (hackrf one ).The bandwidth of
the DVB-T in ireland is 8 Mhz , and the parametetrs Here in ireland
as following:
Bandwidth: 8 MHz
Stream code rate (hi
prio): FEC 2/3
Stream code rate (lo prio): FEC 2/3
Modulation:
QAM 64
Transmission mode: 8k mode
Guard interval:
1/32
Hierarchy: none
net_data_rate = 24.128 Mbits/s
I used dvbt_rx_demo_8k_QAM64_rate78.grc flow graph with the following changes :
frequency of hackrf Mhz, sampling rate = ((8*8e6)/7).
Cyclic Prefix to (8192/32, is this right?)
Code Rate HP : 2/3
Code Rate LP : 2/3
Guard Interval : 1/32
The problem i have is that no output data coming out after the demod_reference_signals BLOCK(no cancellation map), and got the following:
restart aquisition
OOrestart aquisition
d_freq_offset: -5
Od_freq_offset: -5
d_freq_offset: -5
d_freq_offset: -5
d_freq_offset: -5
d_freq_offset: -5
d_freq_offset: -5
d_freq_offset: -5
restart aquisition
OOd_freq_offset: -5
d_freq_offset: -5
so I had to add a signal source to shift the signal. After shfting the signal i got the following :
restart aquisition
restart aquisition
restart aquisition
restart aquisition
Orestart aquisition
I have read a lot about DVB , mapping ,ofdm and others, i have spent weeks on this but still the same problem, if it is synchronization problem what i should do?
So please i need a some help with this problem .
Thanks
Ihab
dvbt_rx_demo_8k_QAM64_rate23_TestComReg.grc.png
Description: PNG image
dvbt_rx_demo_8k_QAM64_rate23_TestComReg.grc
Description: application/gnuradio-grc
[Prev in Thread] | Current Thread | [Next in Thread] |