[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Baudline sink ist missing

From: Rebecca
Subject: Re: [Discuss-gnuradio] Baudline sink ist missing
Date: Wed, 9 Dec 2015 03:23:07 -0700 (MST)

Hi Marcus,
 a) Yes
 b) Yes (i don't know how the preamble or synword or data my bell push are
looking  that is what i want know too) here is a  
     protocol of it: 

C) with a scope and with Baudline after the "complex to mag block" i can
detect the (0's and 1's) transferm like low and high.
     it is three burst i zoomed so that you can see nearly the bit transfer. 

  when the scope sink is after the MM clock recovery  i can also see the
transfern von low and high with Baudline too.But the transfer is slow i
think because the data_rate (19200) reduce the speed in the MM clock
recovery. But the Transfer is looking gut with baudline.


but i cannt zoom in i can only zoom out and it see like.


but when the scope sink is after the  binary slicer i see nothing with
Baudline just  


and i cannot conect the Binary slicer output  with a scope sink.

Best regards

View this message in context: 
Sent from the GnuRadio mailing list archive at Nabble.com.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]