Probably lacks an FPU, which means rather slow floating point emulation.
The CPU just can't keep up in real-time. FluidSynth uses floating point
math heavily.
Best regards,
Element Green
On Oct 12, 2012 11:06 AM, "Simon Eigeldinger" <address@hidden>
wrote:
Hi all,
I am new to fluidsynth and i tried it to run it on my raspberry pi
computer.
its a small ARM board with a 700 mhz processor and 256 mb ram.
When i tried it it played the file for a few seconds and then it strated
to kind of grind or hum. sounded like a saw wave tone got quite low but
went up and down the scale.
here's the output of the console:
$ fluidsynth -a alsa /usr/share/sounds/sf2/FluidR3_**GM.sf2 10.mid
FluidSynth version 1.1.5
Copyright (C) 2000-2011 Peter Hanappe and others.
Distributed under the LGPL license.
SoundFont(R) is a registered trademark of E-mu Systems, Inc.
fluidsynth: warning: Failed to pin the sample data to RAM; swapping is
possible.
Parameter '10.mid' not a SoundFont or MIDI file or error occurred
identifying it
.
fluidsynth: warning: Requested a period size of 64, got 256 instead
Type 'help' for help topics.
fluidsynth: warning: Failed to set thread to high priority
fluidsynth: warning: Failed to set thread to high priority
Anyone knows thats wrong?
I also tried timidity but the annoying thing with it is that you have to
create a channels configuration file first before you are able to use the
soundfont.
Any help appreciated.
Greetings,
Simon
______________________________**_________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/**mailman/listinfo/fluid-dev<https://lists.nongnu.org/mailman/listinfo/fluid-dev>
_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev