[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Gcl-devel] Re: solaris

From: Camm Maguire
Subject: [Gcl-devel] Re: solaris
Date: 08 Mar 2002 11:41:45 -0500

Greetings!  Thanks Dan!

Here is the problem, I think:

from 'one':

add-defs1 solaris
cc -DUNIX -o file-sub file-sub.c
/usr/ucb/cc:  language optional software package not installed

from 'two':

make: *** [file-sub] Error 1
add-defs1: ./bin/file-sub: not found
mv: cannot access tmpx
add-defs1: ./bin/file-sub: not found
mv: cannot access tmpx

Can you find out why file-sub is not being compiled?  The
add-defs/file-sub is what puts the right defs in the makefiles.  What
you are seeing in the main makefile is what is in CVS, which reflects
the i386 Linux build I did when I last committed the file (note the
comments in the file).

I know this is a very dirty setup, but it hasn't been properly fixed
yet, although this should be relatively easy, though of low priority.
Right now, *any junk* in the makefiles between # begin makedefs and
# end makedefs will be replaced by configure.  I therefore have thus
far followed Dr. Schelter's pattern of committing the whole makefile
from my sample build when something changes outside this region.  This
introduces stuff particular to my system in the replace region, but it
should be of no consequence, as it is overwritten.  

Take care,

address@hidden writes:

> I just sent you the results of configure on solaris.  I made sure that
> readline libs were not in the lib directories, but the makefile still
> has them in the linker options.
> Dan

Camm Maguire                                            address@hidden
"The earth is but one country, and mankind its citizens."  --  Baha'u'llah

reply via email to

[Prev in Thread] Current Thread [Next in Thread]