[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: trange problem with 6310I and bluetooth.

From: Toby Fisher
Subject: Re: trange problem with 6310I and bluetooth.
Date: Tue, 1 Jun 2004 13:24:53 +0100 (BST)

On Tue, 1 Jun 2004, Timothy Murphy wrote:

> On Tuesday 01 June 2004 12:48, Toby Fisher wrote:
> > I'm trying to use a ub bluetooth device to communicate with my 6310I for
> > sending sms messages etc.  I've managed to pair the devices without a
> > problem, I used sdptool to figure out which rfcomm channel I needed, I
> > assume it's the one for COM 1 on the phone, and all seemed well.  However,
> > once I've made 1, sometimes 2, connections to the phone, I can get no
> > further response from it,gnokii complains that the resource is temporarily
> > unavailable.  I can use hcitool to scan for the phone, but i can no longer
> > l2ping it, or anything.  In addition, trying to send an sms message gives
> > me a command failure error, seemingly from the network as data appears to
> > go out from the phone.
> I'm not a gnokii or bluez guru,
> but I would suspect the problem lies in the computer, not the phone.
> What kernel are you running?


> Do you have CONFIG_BT_HCIUSB_SCO  set
> i(n .config or /proc/config.gz) ?
> On my machine (a Sony C1VFK Picturebook)
> I had more or less your problems when this was set.

No, I turned it off on I think it was your advice on the Bluez list.

> Basically, when a call ended and the bluetooth device was disconnected
> it was impossible to re-start it, even with
>       service bluetooth restart
> (Did you try that, or equivalent, by the way?)

Yes, but unfortunately it seems that usb bluetooth doesn't like being 
restarted, it's a known problem apparently.


Toby Fisher     Email: address@hidden
Tel.: +44(0)1480 417272 Mobile: +44(0)7974 363239
ICQ: #61744808

reply via email to

[Prev in Thread] Current Thread [Next in Thread]