Re: [gpsd-users] gps source detection problem (GNS1301 receiver, serial port, gpsd 3.15 and current git, ARM cortex A8)

[Arndt Kritzner]

Hi Gary,

ok. Whith the correct (Mediatek) driver the GPS now also works with gpsd 3.15. 
Thanks. It was a bit surprising for me to
se the baudrate autodetection instead of falling back to generic NMEA183. But 
so what.

Thanks + Regards
Arndt

Am 02.10.2015 um 20:58 schrieb Gary E. Miller:
> Yo Arndt!
> 
> On Fri, 2 Oct 2015 09:24:54 +0200
> Arndt Kritzner <address@hidden> wrote:
> 
>>> If you set the port properly before starting gpsd then you avoid
>>> the lengthy autobaud sequence.  You can also compile gpsd for
>>> just the GPS you are using to avoid trying to probe for GPS you
>>> do not support.
>>
>> this is what I did. In my case the autobaud sequence never succeeds
>> (at least not for some hours).
> 
> If you set the port to match the GPS before starting gpsd then the
> problem is not related to the autobaud.  A good look with -D6 will
> likely show your GPS type was not properly detected, maybe due to
> over aggressive removal of unwanted GPS types.
> 
> RGDS
> GARY
> ---------------------------------------------------------------------------
> Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
>       address@hidden  Tel:+1 541 382 8588
> 

-- 

--
###############################################################
Dipl. Ing Arndt Kritzner    Tel:    (0385) 3993 448
Logic Way GmbH              Fax:    (0385) 3993 458
Hagenower Strasse 73        HTTP:   http://www.logicway.de
19061 Schwerin              email:  mailto:address@hidden
###############################################################