ltib
[Top][All Lists]
Advanced
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Ltib] (no subject)

From: jayanthkumar.m.j kumar
Subject: [Ltib] (no subject)
Date: Fri, 25 Jan 2013 15:07:51 +0530
Hai,
           I am using imx23 evk board and  L2.6.31_10.05.02_ER_source(Ltib) BSP to build images,

           doing fine with images but not able to get eth0 after i booted from sdcad, while configuring Ltib i selected

           boot stream option and i set the ip-address

           started networking, enabled Interface 0 and set the ip, broadcast netmask and gateway address




--
Regards
Jayanthkumar
9844598977

 

reply via email to
[Prev in Thread] Current Thread [Next in Thread]