[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Ltib] Not able to use network device(eth0)in imx23
|
From: |
jayanthkumar.m.j kumar |
|
Subject: |
[Ltib] Not able to use network device(eth0)in imx23 |
|
Date: |
Fri, 25 Jan 2013 15:15:55 +0530 |
Hai,
I am using imx23 evk board and L2.6.31_10.05.02_ER_source(Ltib) BSP to build images,
doing fine with images but not able to get eth0 after i booted from sdcad, while configuring Ltib i selected
boot stream option and i set the ip-address
started networking, enabled Interface 0 and set the ip, broadcast netmask and gateway address.
But im not able to get eth0, while booting it showing "IP-Config: No network devices available"
with this mail i attached the boot information, Please do needed.
--
Regards
Jayanthkumar
9844598977
boot-info
Description: Binary data
- [Ltib] Not able to use network device(eth0)in imx23,
jayanthkumar.m.j kumar <=