[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] Tiny v2

From: Uttam Chandrashekhar
Subject: [Paparazzi-devel] Tiny v2
Date: Fri, 4 Jan 2008 02:41:30 -0800 (PST)

Hi Guys,

I'm back! The new 2 layer board has been populated and powered on. At 7V, current draw is a steady 35ma. Since this is a new board, what are the steps I should follow after power up? The 3.3V is working fine, so the power supply is working OK. Should I try a reset like the instructions at wiki for the v1.1 suggest? Unlike in the older 4 layer board design, there is no reset pin available at the serial connector.

Happy new year to everyone here!

Thanks in advance,

Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
reply via email to

[Prev in Thread] Current Thread [Next in Thread]