[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] First power-up of Autopilot OK, some questions

From: Martin P
Subject: Re: [Paparazzi-devel] First power-up of Autopilot OK, some questions
Date: Thu, 14 May 2009 23:15:43 +0200


You mean I should go to maximum baudrate? 
Currently I am using an old and slow laptop. This is part of the reason to stay 
with 9600. 
Does loss of modem connection cause an empty GCS? 

The GCS looks like this one:
as posted by Dirk-Willem van Gulik in the thread "GCS not populating". 
But I do not get any red error messages in the Paparazzi Center. 
There is a message that says 
Xlib: extension "Generic Event Extension" missing on display ":0.0". 
but it is not red. 

Strange thing: GCS was populated on the first try and then, without any 
changes, no longer. When I build for the simulator and run it, it works.

Greetz, Martin 

-------- Original-Nachricht --------
> Datum: Wed, 13 May 2009 21:24:07 +0100
> Von: Gareth Roberts <address@hidden>
> An: address@hidden
> Betreff: Re: [Paparazzi-devel] First power-up of Autopilot OK, some   
> questions

> XBEE Pro 868's will only stay connected for 4-5 min @ 9600.
> This is due to their 10% duty cycle.  Someone on the list mentioned he 
> solved this by attaching the reset pin to the tiny and writing a module 
> to reset the xbee every few minutes.
> Does this sound like it could be your problem?
> --G
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]