[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Paparazzi-devel] Reply #2 to: "PPM encoder : channels not responding wh
[Paparazzi-devel] Reply #2 to: "PPM encoder : channels not responding when moving stick, quickly on R/C (Philippe Volivert)"
Tue, 09 Nov 2010 20:07:33 +0200
Mozilla/5.0 (X11; U; Linux i686; en-US; rv:126.96.36.199) Gecko/20101027 Thunderbird/3.0.10
Also please can you disable the IPD filter and try again?
I went through the code and there is nothing that can induce that behavior.
The only thing that i can think off is that the chip is defective or
something is wrong with the wiring.
Do you power the receiver from the PPM board?
If not remember to remove the jumper of the PPM board otherwise you will
have two power sources colliding.
Also it is certain that the 8th channel is not recognized during power
up because either the cpu does not see a pulse there or the pin is
If it was then you should get a PPM off led indication when the channel
Tomorrow i will connect an encoder of mine to the 12 channel IPD
receiver and a Royal Evo 12 i have and try to reproduce the problem
although i doubt i will because all the development was done with this
|[Prev in Thread]
||[Next in Thread]|
- [Paparazzi-devel] Reply #2 to: "PPM encoder : channels not responding when moving stick, quickly on R/C (Philippe Volivert)",