[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] hardware and software development Servo_counter

From: Heinrich Warmers
Subject: Re: [Paparazzi-devel] hardware and software development Servo_counter
Date: Tue, 07 Aug 2012 17:00:44 +0200
User-agent: Mozilla/5.0 (Windows; U; Windows NT 5.1; de-DE; rv:1.4) Gecko/20030619 Netscape/7.1 (ax)

one question for the NAVGO v3,
is it possible to add 2 pins SERV_RST (pin 48 ) SERV_CLK (pin29) to a connector or to make solder pads for it? Then this nice autopilot is then able to fly normal wing configuration or multicopter with low cost motor controller (larger device > 40cm) with a separate servo connector pcb shown in the appendix. This pcb is made to solder 2.54 mm connector strips direct for normal servo connectors.


Gautier Hattenberger schrieb:

Hello Sergey and other hw/sw developers,

When you have developed new hardware (autopilots, expansion boards, sensor boards...) or software (driver, new feature,...), do not hesitate to use this mailing list to announce it, send patches/links, or even better use the github pull request service. And of course, documentation on the wiki is always a good idea ;)

All this OSD discussion shows that people are making a lot of nice stuff around the Paparazzi project and that even more people want to use them! We are really willing to help more developers to share their amazing work and contribute to this project.

If you have any questions on how to contribute, have a look at this page: or contact us on this mailing list.

Happy hacking


Paparazzi-devel mailing list

Attachment: hb_servo.pdf
Description: Adobe PDF document

Attachment: hb_servo_sch.pdf
Description: Adobe PDF document

reply via email to

[Prev in Thread] Current Thread [Next in Thread]