[Xlog-discussion] 706 mkii trace

[James Crawford]

Joop,
    I could not find src/main.c while attempting to edit line 400.
Below is the what the directory holds:

address@hidden src]$ ls
cal.c                    libhamlib_la-locator.o    Makefile
cal.h                    libhamlib_la-misc.lo      Makefile.am
conf.c                   libhamlib_la-misc.o       Makefile.in
conf.h                   libhamlib_la-register.lo  misc.c
event.c                  libhamlib_la-register.o   misc.h
event.h                  libhamlib_la-rig.lo       register.c
iofunc.c                 libhamlib_la-rig.o        rig.c
iofunc.h                 libhamlib_la-rotator.lo   rotator.c
libhamlib.la             libhamlib_la-rotator.o    rot_conf.c
libhamlib_la-cal.lo      libhamlib_la-rot_conf.lo  rot_conf.h
libhamlib_la-cal.o       libhamlib_la-rot_conf.o   rot_reg.c
libhamlib_la-conf.lo     libhamlib_la-rot_reg.lo   serial.c
libhamlib_la-conf.o      libhamlib_la-rot_reg.o    serial.h
libhamlib_la-event.lo    libhamlib_la-serial.lo    token.h
libhamlib_la-event.o     libhamlib_la-serial.o     tones.c
libhamlib_la-iofunc.lo   libhamlib_la-tones.lo     tones.h
libhamlib_la-iofunc.o    libhamlib_la-tones.o
libhamlib_la-locator.lo  locator.c
address@hidden src]$ pwd
/home/james/hamlib-1.1.3/src
address@hidden src]$


    Am I in the right spot?
    Thanks,
    James



James, please change line 400 in src/main.c from:
  rig_set_debug(RIG_DEBUG_ERR);
to:
  rig_set_debug(RIG_DEBUG_TRACE);

In case you still have the xlog sources unpacked and configured, just
type 'make', and run src/xlog from your terminal.
Otherwise, you should: './configure --enable-hamlib; make; src/xlog'.

The trace will be quite hefty, because the rig is polled 3 times a
second....