[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-chat] How can I individualise specific CPUs?
From: |
Eric Pasquier |
Subject: |
Re: [avr-chat] How can I individualise specific CPUs? |
Date: |
Fri, 18 Sep 2009 09:56:44 +0200 |
Dear Juergen,
What about an external SPI/I2C eeprom ?
Eric
----- Original Message -----
From: "Juergen Harms" <address@hidden>
To: "avr-chat" <address@hidden>
Sent: Friday, September 18, 2009 9:45 AM
Subject: [avr-chat] How can I individualise specific CPUs?
I wonder whether there is some approach to provide specific CPUs with
some program-readable identifier that allows to individually recognise
each CPU in a way that survives programming operations that start by
erasing the chip.
To be more clear, here is why I need this: I am having a bus with many
AT90CAN nodes, each of them driving timed events. The CPU clock of each
node is used to generate the necessary clock information. I use a
polynomic correction algorithm to correct hardware-specific clock
deviation, having a polynome which is specifically defined for each CPU
(resp. its PCB).
At present, I maintain a list of CPUs and their individual correction
polynomes and manually introduce them into the object code before a
device is re-programmed. That is a tedious and error-prone way of doing
(even if I store the polynome in eeprom and only need to adapt the
object code when eeprom is re-programmed).
I would like to automatize the manual procedure by some lookup algorithm
that uses a CPU id as a key. Has anybody come across this problem and
found a solution? The ideal way would be to have a zone of the eeprom (a
single byte would be enough) that is protected against
programming-triggered erasure, and that can be used by the application.
(Note: during normal operation, there is a DCF-driven master timer that
sends timer messages over the bus, allowing the nodes to synchronize;
but the system must continue to work even if temporarily the master
timer goes away - hence the need to adapt each node at least with a
basic timer-offset correction).
_______________________________________________
AVR-chat mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/avr-chat
- [avr-chat] How can I individualise specific CPUs?, Juergen Harms, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?,
Eric Pasquier <=
- Re: [avr-chat] How can I individualise specific CPUs?, Bernard Fouché, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Juergen Harms, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Juergen Harms, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Peter LaDow, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Graham Davies, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Bill Gatliff, 2009/09/18
- Re: [avr-chat] How can I individualise specific CPUs?, Juergen Harms, 2009/09/19
- Re: [avr-chat] How can I individualise specific CPUs?, Peter Fuhrmann, 2009/09/22
- Re: [avr-chat] How can I individualise specific CPUs?, David VanHorn, 2009/09/22