I have downloaded and built the GNU radio source code release 3.0 (Minimal
Build) on cygwin. The installation went without any error. But when i tryied to
run the sample dial_tone.py, i didnt get any error but at the same time there
was no dial tone sound at the output. So i checked that the "WAVE" source was
enabled in the audio control panel as instructed, but still no output
Earlier when i was installing the wxpython
module as stated in the page
all the steps went well, but when i tried to run
the demo.py as indicated in the 13th step, I didnt get the output and no error
was reported. I feel these two issues have a link and hence i tried the steps
once again, but then got the same problem again.....No Output and No error...
Where could the problem be??
Solution to this problem could be very very