Re: [Discuss-gnuradio] output 0 is not connected internally

[Marcus D. Leech]

On 12/30/2010 12:39 PM, George S. Williams wrote:

On 12/30/2010 12:16 PM, Brad Hein wrote:

Unfortunately the compile failed - I ran into compile errors with things in the usrp2 and gr-usrp2 directories, so I removed them from the Makefile and the compile eventually went through... But make install didn't seem to install any new grc binaries. I made sure to run configure with --with-grc, so I don't think it's being skipped.

Is anybody else out there working on getting gnuradio working in Fedora14 who would like to join forces?

I've been running Gnu Radio on F14 for quite some time.

Following the instructions in the build guide, make sure you have the pre-reqs, and you should be good to go.

http://gnuradio.org/redmine/wiki/gnuradio/BuildGuide

If you go the UHD route (which I recommend), you'll need to set PKG_CONFIG_PATH to point at /usr/local/lib/pkgconfig before doing the
  configure and make steps for gnu radio.

-- 
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org