Well, that sounds like the lazy solution, intermodulation
products are bad, so just throwing the transmitter power away is not
what I'd prefer.
But what it points to is an *analog* issue, entirely independant of the
CORDIC (which, as I observe, isn't likely involved in the test cases
at hand here).
Analog gain elements (including DACs) have operating regions over which
they're linear, and operating regions over which they're not
linear. If you drive any amplifier near its maximum operating point,
it will start to become non-linear to one degree or another. I'll
let Matt or one of the other engineering folks at Ettus comment
further, but I personally am totally unsurprised when things start to
become non-linear near the nominal maximum operating point.
Is there any way of finding out what the resolution is? We
haven't been able to track it down for the RFX2400 board,
but this sounds like a nice way to test if it _is_ the
CORDIC.
Look at the tune_result_t from tuning:
http://files.ettus.com/uhd_docs/doxygen/html/structuhd_1_1tune__result__t.html
If the actual_dsp_freq is 0, then the CORDIC wasn't involved.
I tuned to an even number of MHz, which on all of the synthesizers
*should* yield 0 CORDIC frequency.
But maybe Josh can add a feature to 'uhd_usrp_probe' to display the PLL
resolution (although in some cases,
it may change with target frequency range, I think).