[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen
From: |
Martin Braun |
Subject: |
Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen |
Date: |
Tue, 17 Feb 2015 11:18:43 +0100 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.4.0 |
On 02/17/2015 08:21 AM, zealdeal wrote:
> I'm bit confused here.
>
> You said "In the OFDM example, watch the amplitude of the signal before it
> enters the USRP sink. If it exceeds 1.0, I promise it will clip"
>
> I transmitted OFDM symbols, keeping transmission amplitude as 0.2
>
> Then, on the collected log, I ran gr_plot_ofdm.py tool. It shows the plot of
> transmitted signal in time domain.
>
> I see that the amplitude is much more than 1 in that plot.
>
> Could please tell me where am I going wrong?
I'm not even entirely sure what gr_plot_ofdm.py does.
If your signal amplitude is smaller than 1.0 before it goes to the
usrp_sink, you're good.
Cheers,
M
- [Discuss-gnuradio] Amplitude settings in uhd_siggen, zealdeal, 2015/02/10
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Martin Braun, 2015/02/10
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, zealdeal, 2015/02/11
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Martin Braun, 2015/02/11
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Ron Economos, 2015/02/11
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Marcus Müller, 2015/02/11
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Martin Braun, 2015/02/11
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, zealdeal, 2015/02/17
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen, Marcus Müller, 2015/02/17
- Re: [Discuss-gnuradio] Amplitude settings in uhd_siggen,
Martin Braun <=