Re: Segfault 2.15.23 Span_bar_stub_engraver

[Jay Anderson]

On Tue, Jan 3, 2012 at 1:12 AM, address@hidden
<address@hidden> wrote:
> On Jan 3, 2012, at 9:02 AM, David Kastrup wrote:
>> If he hadn't rerun configure since before version 2.15.21, I think that
>> the compilation would likely have failed for other reasons.  The problem
>> report is for 2.15.23.  It may be worth for him to report the CXXFLAGS
>> setting in config.status just to be on the safe side, but I consider it
>> unlikely that this particular problem has not already been covered.
>>

I pulled down lilypond and build new just last week.

CXXFLAGS in config.status is:
- With optimization (default): "O2 -finline-functions -g -pipe
-fno-optimize-sibling-calls"
- Without optimization: "-g -pipe -fno-optimize-sibling-calls"

> Are you using an optimized binary?  Mine is unoptimized.  Please try 
> ./autogen.sh --disable-optimizing before compiling and let me know if that 
> makes the segfault go away.

I found --disable-optimising instead. Same result.

I can't reproduce this on my wife's mac or on my laptop (also running
ubuntu 11.10). The only difference I can think of is I'm running
64-bit and my laptop is 32-bit. Unless someone else can reproduce this
issue don't spend much more time on this. I have a good solution
(adding in the dynamics). Thanks!

-----Jay