Re: Pedal at wrong position

[Mats Bengtsson]

One workaround is to use the following setting,
       \override Staff.SustainPedalLineSpanner #'staff-padding = #5
and adjust the number 5 to be large enough that all pedal marks are as 
low as the lowest one in the score but not too large so that the pedal 
marks end up being too low. The value specifies the minimum distance to 
the stave.

   /Mats

stefankaegi wrote:
> Sorry, that I write again, but it's very urgent. Maybe it wasn't clear
> what I meant. There is an example image in the mail. As you see the
> pedal isn't always at the same height. How could I fix that?
>
> Thank you for your answers
>
> Best wishes
> Stefan
>
> Am Sonntag, den 13.12.2009, 14:06 +0000 schrieb Neil Puttock:
>   
> > 2009/12/12 James Bailey <address@hidden>:
> >
> >     
> > > This means this:
> > > \new Staff = "LH" << \LH \pedal >>
> > >       
> > This will only work if the skips in \pedal coincide with notes in \LH,
> > otherwise the brackets will still be misaligned.
> >
> > Regards,
> > Neil
> >     
> >
> > ------------------------------------------------------------------------
> >
> > ------------------------------------------------------------------------
> >
> > _______________________________________________
> > lilypond-user mailing list
> > address@hidden
> > http://lists.gnu.org/mailman/listinfo/lilypond-user
> >     

--
=============================================
        Mats Bengtsson
        Signal Processing
        School of Electrical Engineering
        Royal Institute of Technology (KTH)
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
       Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================