[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Ltib] dbus for LTIB, mx27 target
From: |
Stuart Hughes |
Subject: |
Re: [Ltib] dbus for LTIB, mx27 target |
Date: |
Fri, 08 Feb 2008 09:45:23 +0000 |
Hi Peter,
Can you check that zlib has been enabled in your configuration (./ltib
-m config). If it has can you send some output showing the failure.
Regards, Stuart
On Fri, 2008-02-08 at 09:39 +0000, Peter Wurmsdobler wrote:
> Hello,
>
> Did anyone ever try to compile dbus for an imx27 with ltib? Well, I'm
> trying to add it following the stand procedure. This is not the issue, I
> only have a few compile problems.
>
> First, configure complains that there are no abstract sockets. Changing
> the configure.in (adding something like abstract socket == no) and
> autoconf takes care of that.
>
> However, then I have troubles with a linker issue. It complains that
> when linking the dbus deamon, libxml (which compiles without any
> problem) has unresolved zlib symbols. Very strange.
>