Yo David!
On Thu, 14 Jan 2021 10:52:19 +0000
David Taylor<gm8arv@yahoo.co.uk> wrote:
During tests I had already exported the correct protocol,
A little detail you neglected to mention.
but I
tested again with:
sudo su
Enough with the sudo! Just sudon't! ubxtool does not need to
be run as root.
ubxtool -e GALILEO -P 18.00
and the setting was not retained over a hot reboot.
Nor would I expect it to be. Saving things in u-blox is a very
complicated subject. It depends wildly on receiver version and
the PCB it is on. I guess I need to add examples on that.
Are you referring to "$ ubxtool -p RESET" in the examples page?
Yes. Specifically this section:
https://gpsd.io/ubxtool-examples.html#_initial_setup
I'
not sure otherwise. How should I do the enable of Galileo
automatically?
Specific directions on constelattions are here:
https://gpsd.io/ubxtool-examples.html#_constellations
I tried with RESET first and the Galileo was not
retained.
Nor would I expwect it to be. RESET is about resetting, not about
saving. To save you use the SAVE option to ubxtool. But even then
almost no u-blox on the consumer market will retain anything.
Your best bet ot to always rconfigure the reeiver just before you run
gpsd. Or use tpsd device hook.
RGDS
GARY