[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] RC-link status indicator in gcs do not work as exp

From: Gerard Toonstra
Subject: Re: [Paparazzi-devel] RC-link status indicator in gcs do not work as expected
Date: Mon, 17 Sep 2012 18:13:28 -0300

In the transmitter. The typical range is 1000-2000, but if you specify -125% and 125% in the settings menu of the transmitter,
this would then become 750-2250 (depending if it's actually precise, or just some "indication").
Anyway, it will be well below the minimum throttle when you pull the stick backwards. 950 should be enough already.

Hmm.. you should also verify this against bad packet detection and what the ppm module does. I believe it uses the intervals
to verify if there are bad packets coming in vs. just no packets at all. Not sure if that amounts to the same thing, so it's good to check.


On Mon, Sep 17, 2012 at 6:02 PM, Jorn Anke <address@hidden> wrote:
This is a bit cryptic to me. Should it be set by the RC tx/rx, in one of the config-files, or something else?



Another trick is to increase the throw to 125%, throttle to zero, set failsafe 
and set throw back to 100%.



Paparazzi-devel mailing list

Gerard Toonstra

reply via email to

[Prev in Thread] Current Thread [Next in Thread]