[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] RC-link status indicator in gcs do not work as exp

From: Balazs GATI
Subject: Re: [Paparazzi-devel] RC-link status indicator in gcs do not work as expected
Date: Tue, 18 Sep 2012 08:42:48 +0200
User-agent: Mozilla/5.0 (Windows NT 5.1; rv:15.0) Gecko/20120907 Thunderbird/15.0.1

Some info regarding failsafe mode:


2012.09.17. 23:13 keltezéssel, Gerard Toonstra írta:

In the transmitter. The typical range is 1000-2000, but if you specify
-125% and 125% in the settings menu of the transmitter,
this would then become 750-2250 (depending if it's actually precise, or
just some "indication").
Anyway, it will be well below the minimum throttle when you pull the
stick backwards. 950 should be enough already.

Hmm.. you should also verify this against bad packet detection and what
the ppm module does. I believe it uses the intervals
to verify if there are bad packets coming in vs. just no packets at all.
Not sure if that amounts to the same thing, so it's good to check.


On Mon, Sep 17, 2012 at 6:02 PM, Jorn Anke <address@hidden
<mailto:address@hidden>> wrote:

    This is a bit cryptic to me. Should it be set by the RC tx/rx, in
    one of the config-files, or something else?




    /Another trick is to increase the throw to 125%, throttle to zero, set 
    and set throw back to 100%.



    Paparazzi-devel mailing list
    address@hidden <mailto:address@hidden>

Gerard Toonstra

Paparazzi-devel mailing list

Balazs GATI, PhD
     Department of Aircraft and Ships
     Budapest University of Technology and Economics

Address:   Budapest
          Stoczek u 6. J. ép. 423
Tel:       +(36)-1-463-1960
Fax:       +(36)-1-463-3080

reply via email to

[Prev in Thread] Current Thread [Next in Thread]