[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] lisa m and ppm input

From: Cedric Marzer
Subject: [Paparazzi-devel] lisa m and ppm input
Date: Wed, 3 Oct 2012 22:26:40 +0200

I am trying to connect a ppm receiver to a lisa m V2 board. I'd need all 8 
servo outputs.
Apparently the ppm input is supposed to be connected to the servo No 6 output. 
Is there an alternative way to connect it to the uart 1 rx pin ? I am not 
familiar with the STM32 so I am not sure how difficult it would be to adapt the 
code (and if it is possible at all). Any help appreciated.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]