[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Discuss-gnuradio] USRP and "fusb: (rd status -71) Protocol error"

From: Steve Glass
Subject: [Discuss-gnuradio] USRP and "fusb: (rd status -71) Protocol error"
Date: Wed, 2 May 2007 21:33:48 +1000


I've a rev 3 USRP which has the Flex2400 and TVRX daughtercards installed.
At one time the setup worked well - altho I've let it lie a while. This week I've swapped out a TVRX and replaced it with the DBSRX in preparation for a new project.

When I run usrp_fft.py things are fine for a few moments but inevitably the program crashes with:

fusb: (rd status -71) Protocol error

repeatedly written to the terminal. Similar story for usrp_oscope.py and most other examples.

This occurs both when using the Debian packages (3.0.2-2). When using the latest subversion build I sometimes get the error during the test_usrp_standard_rx "installation" stage but often it works and produces results such as:

xfered 1.34e+08 bytes in 4.19 seconds.  3.2e+07 bytes/sec.  cpu time = 0.184
noverruns = 0

What is the "Protocol error" error caused by and how can I fix it?

Kind regards,


reply via email to

[Prev in Thread] Current Thread [Next in Thread]