|Subject:||[Discuss-gnuradio] setup of usrp N100/N200|
|Date:||Mon, 21 Oct 2013 10:07:46 +0530|
I have followed as per the instructions given in the webpage
for set up of the Usrp N200/N210 but still i am unable to communicate between
the hardware and host pc
1.I have set the static ip of the host pc to 192.168.10.1(ifconfig eth0 192.168.10.1).
2.Whenever i give the device address=addr=192.168.10.1 and run the grc i am getting the error has “unknown key format”
3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i am getting warning as “NO DEVICE FOUND “
4. Is that a must i have to upload the fpga and firmware images when using the device for the first time.
5.Sometimes i am getting an error like” unable to find as single device”.
6.The host pc is supporting only 10/100MBPS .Is that the only problem so that i am unable to communicate with the hardware.
Can anybody help me on this issue.Awaiting for your valuable reply
Thanks in advance
|[Prev in Thread]||Current Thread||[Next in Thread]|