|
From: | Activecat |
Subject: | Re: [Discuss-gnuradio] setup of usrp N100/N200 |
Date: | Mon, 21 Oct 2013 12:54:25 +0800 |
Thanks for the reply.Well is that only problem so that i'm unable to communicate and should i need to update the firmware?Thanks and regardsSandhya.GOn Mon, Oct 21, 2013 at 10:19 AM, Activecat <address@hidden> wrote:
Your pc must have 1000Mbps port. The 10/100Mbps won't work.An alternative is to connect a 10/100/1000 LAN switch between your pc and the USRP.Rgds,activecat.
On Mon, Oct 21, 2013 at 12:37 PM, Sandhya G <address@hidden> wrote:
_______________________________________________HI all,
I have followed as per the instructions given in the webpage for set up of the Usrp N200/N210 but still i am unable to communicate between the hardware and host pc
1.I have set the static ip of the host pc to 192.168.10.1(ifconfig eth0 192.168.10.1).
2.Whenever i give the device address=addr=192.168.10.1 and run the grc i am getting the error has “unknown key format”
3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i am getting warning as “NO DEVICE FOUND “
4. Is that a must i have to upload the fpga and firmware images when using the device for the first time.
5.Sometimes i am getting an error like” unable to find as single device”.
6.The host pc is supporting only 10/100MBPS .Is that the only problem so that i am unable to communicate with the hardware.
Can anybody help me on this issue.Awaiting for your valuable reply
Thanks in advance
Sandhya.G
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |