Re: Galileo Frequency Shifting and Filtering

[It's a cat]

Amplifier only increase power (signal plus noise), they can't give you better SNR.

Anyway, It's much better to use a CW signal generator to help you debug the frequency converter chain (remember to keep output power low, e.g. -60dBm). You can use freq sink to check every stage of your flowgraph, and use Range / slider widget to control block parameters to search and check. If the signal disappears, or the passband doesn't meet your requirement, the problem can be easily located.

David Dima <daviddimavd@gmail.com> 于2023年3月1日周三 21:50写道：

Hi,

Sure, but the power of this kind of signals is below noise level. Current antenna amplifies 30dB but it still not enough to see anything in the spectrum (I have checked it alredy).

Regards,

David

El mié., 1 mar. 2023 7:27, It's a cat <luoshumymail@gmail.com> escribió:

If you have a signal generator, GNSS simulator or a high gain antenna, you can verify your settings by adding a spectrum display (Qt Freq Sink) or something like that to your receiver path.

Because many things can go wrong in your setup, if you misunderstand something. Just try to verify this directly. If there's a signal you should be able to see it on the spectrum display.

David Dima <daviddimavd@gmail.com> 于2023年2月28日周二 02:00写道：

Hi guys,

I am trying to simultaneously record Galileo's E5a and E5b signals as follows:

I have tried to record them separately by tuning the local oscillator in the middle of the signals bandwidths and sampling at 25MHz and it worked. But when I try to shift and filter to get the signals in a different file, it does not work. I have no idea what am i doing wrong.

Galileo's Signal Plan is as follows: