|Subject:||Re: [Paparazzi-devel] Powering Lisa/M 2.0|
|Date:||Tue, 6 May 2014 00:55:46 +1000|
Perhaps you can power both rail with the same BEC.
2014.05.04. 1:28 keltezéssel, Dylan Brunello írta:
Thanks Piotr and Chris.
On Sunday, 4 May 2014, Chris <address@hidden<mailto:address@hidden>> wrote:
No problem at all if you don't parallel the output of 2 or more BECs.
Sometimes linear BECs (switchmode never) can be paralleled but this
is not a good practice in any case.
In other words if you use more than one BEC in a split load
configuration but make sure that their + rail is not paralleled.
On 05/03/2014 01:59 PM, Dylan Brunello wrote:
I have a Lisa/M 2.0 configured with the default power jumpers. I'd
like to power everything in the system from a single battery (3S
LiPo). The plan is to power the servo rail using the 5V BEC on the
ESC. Is it safe to connect an additional 5V BEC to the battery and
use that to power the Lisa and peripherals? My concern is the two
BECs on the one battery. Any thoughts regarding powering the
system in this fashion?
Paparazzi-devel mailing list
Balazs GATI, PhD
Department of Aeronautics, Naval Architecture and Railway Vehicles
Budapest University of Technology and Economics
Stoczek u 6. J. ép. 423
|[Prev in Thread]||Current Thread||[Next in Thread]|