[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] GNU Radio on Zedboard

From: Alireza Khodamoradi
Subject: Re: [Discuss-gnuradio] GNU Radio on Zedboard
Date: Wed, 18 Mar 2015 21:44:52 -0700


Thank you for letting me using your images. I tried both of them with the dd command, it took me around 2000 seconds (30 mins) each and after using them on the board I get the following message via the UART:

U-Boot SPL 2014.01 (Jan 09 2015 - 20:24:45)
mmc boot
reading fpga.bin
spl: error reding image fpga.bin, err - -1
reading system.dtb
spl: error reading image system.dtb, err - -1
reading u-boot.img
spl: error reading image u-boot.img, err - -1
### ERROR ### Please RESET the board ###

I got the above message for sdimage-8G-zc702.direct. I get no message for the other image.

What am I doing wrong?

On Fri, Mar 13, 2015 at 11:22 AM, Philip Balister <address@hidden> wrote:
On 03/13/2015 01:17 PM, Alireza Khodamoradi wrote:
> Hello everyone,
> I'm going through the instructions from here:
> http://gnuradio.org/redmine/projects/gnuradio/wiki/Zynq

I should go over those carefully, but in the mentime I have some images
built for the zedbaord here:


Take the zedboard one, uncompress it and write it to an sd card. Be sure
to unmount (not eject) the sd card and run:

sudo dd if=sdimage-8G-zedboard.direct of=/dev/sdX

where sdx is the device the sd card is on.


> to get a working image with gnu radio for my zedboard.
> Unfortunately I can't get the board to boot with this image. I was
> wondering if someone can help me.
> what I tried so far ( all failed - can't boot from the SDCard):
> - default settings in the instructions
> - renaming u-boot.bin to boot.bin
> - renaming u-boot.bin to BOOT.BIN
> - renaming uImage--zedboard-zynq7.dtb to devicetree.dtb
> - I tried command line as well as gparted gui.
> what I checked:
> - download a linux from XillyBus and boot the board with SDCard -> works
> v/r
> Alireza
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

reply via email to

[Prev in Thread] Current Thread [Next in Thread]