Re: ✘gpscsv

[Andreas B]

Hi Gary,

I've enabled subframes with
    ~ # ubxtool -e SFRBX

but I'm confused how I increase the speed. It's 9600 at the moment,
and I figured I would try to set it to 38400. Any other
recommendations? I'm connected with the F9P with USB if it matters.

So I try with
    ubxtool -S 38400

but when I connect to it still says
    [....] "bps":9600 [....]

And not getting any subframe data.

Best,
Andreas

On Thu, Aug 27, 2020 at 7:27 PM Gary E. Miller <gem@rellim.com> wrote:
>
> Yo Andreas!
>
> On Thu, 27 Aug 2020 10:18:50 +0200
> Andreas B <panden@gmail.com> wrote:
>
> > This is very exciting. I'm trying the commands that you wrote, but I'm
> > not getting anything. I'm using a ublox ZED-F9P. Do you have to enable
> > the device to send subframes (and almanac)? With e.g. ubxtool?
>
> Did you first enable subframes from the F9P?  Also, be sure your
> speed is faster than 9600, there is a lot of subframe data.
>
> To enable subfranes:
>         ~ # ubxtool -e SFRBX
>
> To see if you are getting them:
>
>         ~ # ubxtool  | fgrep SFR
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>         UBX-RXM-SFRBX:
>
>
> RGDS
> GARY
> ---------------------------------------------------------------------------
> Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
>         gem@rellim.com  Tel:+1 541 382 8588
>
>             Veritas liberabit vos. -- Quid est veritas?
>     "If you can't measure it, you can't improve it." - Lord Kelvin